Wake On Charge (WOC)

The EVParts Wake On Charge Module (WOC) adds support for J1772 Control Pilot/Proximity Pilot control of vehicle charging for onboard chargers without this functionality.

• J1772 Control Pilot Monitoring
• J1772 Proximity Resistance Measurement
• High side output drivers for RGB LED and BMS Wake Signal
• CAN Bus Communication
• Low Power Sleep State

• Voltage: 12V
• Communication: CAN Bus
• Dimensions: 124mm x 113mm x 40mm
• Connector: CKK724B-1.5-2.5-11
• Weight: 270g
• Mounting Holes: 4x M6
• Mounting Hole Spacing: 102mm x 46mm

• Wiring Guide
• Quick Start Guide (Coming Soon)
• Operating Guide (Coming Soon)
• CAN Specification (Coming Soon)
• 3D Model - JWPF
• Latest Firmware (Coming Soon)

The WOC monitors the Control Pilot (CP) it can detect the voltage level and the PWM duty %. It broadcasts the measurements over CAN, which allows the on board charger to be controlled in accordance with the charge station's allowed parameters.

The WOC monitors the resistance between the Proximity Pilot pin and the PE pin. This allows it to detect the presence of a charging cable in the socket, and to determine the current rating of the cable.

The WOC has three high side drivers designed to control an RGB LED. The operation of the LEDs is controlled via CAN command, this allows the BMS or VCU controlling the charge session to indicate the status to the operator.

The WOC features an H-Bridge motor driver allowing it to control most types of charge socket lock actuators. The type of actuator is configurable via CAN.

Like all PIC based EVParts products the WOC comes loaded with a CAN Bus bootloader. This allows firmware updates to be performed in the field using a USB CAN adapter.